Specifications.
|
Four Basic Models: Single-Hung, Double-Hung, Slider and Picture Windows. Series S-3025/S-3015/S-4025 windows have been structurally tested by Southwestern Test Laboratories in Fort Worth, Texas, and thermally tested by National Certified Laboratories in York, Pennsylvania. Constructed in accordance with AAMA specifications.
Thermalized: Large, thermal-fill cavity with 1/4" poured polyurethane in all frames and sash members. Rigid vinyl thermal insulator on center appendage of main frame.
Full-Perimeter Weather Stripping: For an efficient, positive seal, all windows feature poly-pile, fin-seal and soft vinyl fin weatherstrip.
Weathertight Construction: Inserts and main frames have
coped corners- no miters.
Latch Rails: Hollow extrusion design in meeting rail, except SH-B1-HP60.
Series: Aluminum windows shall be models S-3025, S-3015 or S-4025. Single-Hung window shall conform to AAMA specifications as follows: SH-B1-HP 60, SH-A2-HP 60 and SH-A2-HP 60 Forced Resistance Tested. S-4025 sliding windows shall meet AAMA specifications for HS-B2-HP 50 and HS-A2-HP 50.
Material: Main frames and sash members shall be constructed of 6063-T5 extruded aluminum alloy having a minimum wall thickness of.050 (within commercial tolerances), except for A2 sills which shall be .062 thick.
Glazing: All windows shall be glazed with 3/4" insulated glass using a wrap-around, soft vinyl gasket. Top sash shall be a glazed insert, rather than glazing glass into frame. Fixed lite units shall be interior removable stop glazed.
Weather Stripping: Top sash shall be weatherstripped with fin-seal weatherstrip. Bottom sash shall be double weatherstripped with a combination of soft vinyl fin weatherstrip and poly-pile. Vinyl weatherstrip shall be equal to commercial standard CS230-60.
Hardware: Sash shall be fitted with a die-cast cam type lock at the center of the meeting rail. Sash shall be equipped with block and tackle balances and feature side takeout for reglazing. Slider windows shall be equipped with ball bearing rollers. All screws and fasteners shall be stainless steel or cadmium-plated or zinc-plated per AST specification specification A-164-55 or A-165-55.
Finish: All exposed surfaces of all aluminum members shall be clean and free from serious blemishes. Painting shall be accomplished with an electrostatic process using a polyester baked enamel finish. Hard-coat finishes available on commercial models.
Screens: Screens will be provided when specified with roll-formed frames and will be spring-loaded for retention.
Installation: Assembly and installation shall be done in accordance with good construction practices and with furnished instructions, taking care to protect the finish. This is page four of four. 1 | 2 | 3 | 4 |
|
|
Standard colors
|
Actual colors will vary according to your computer monitor.
|
|
|
|
